Just Say NO ..... to Detention Ponds

1. They take up valuable land

   Detention and retention ponds are typically designed for a storm that has a return interval of 20-100 years, so the volume is rarely, if ever, fully utilized. As a result you have a gaping hole in the ground that is an eyesore, a potential danger to children and basically useless except for those rare occasions when we receive excessive rainfall.

2. They don't address quantity

   Detention and retention ponds rarely address stormwater quantity. Typical stormwater regulations address the peak flow rate and water quality, but do not address the actual amount of water that runs off of a site rather than soaking into the ground. Because of that, even well designed sites with detention ponds significantly reduce ground water recharge, which contributes to drought conditions, increases erosion in stream channels, and limits that amount of water available for plant life.

3. They offer minimal water quality

   Typical stormwater regulations pertaining to detention ponds address water quality in two ways, retention time and/or water quality units. Often, regulations allow water quality to be addressed by requiring the "first flush" (usually around 1/2" of rainfall) be detained and released over a period of 24-48 hours. The idea is that most of the dissolved solids will settle out during this period and the water that is released will be reasonably clean. However, very fine and highly soluble particles will often not settle out during that period, and oils, grease, metals and other contaminates are not effectively removed either. Proprietary water quality units often perform better but have to be used in combination with a pond or other methods and are usually expensive and maintenance intensive.

Don't get me wrong, we are better off with detention ponds than without them, but there are more effective methods for managing stormwater. As with just about anything, one size does not necessarily fit all, and there are going to be times when detention ponds are the best or only solution. I have designed quite a few detention ponds, and I am sure that I will design quite a few more, but I will always look to the following methods first and exhaust those possibilities.

1. Raingardens/Bioretention

   Call them what you like, raingardens, bioretention, bio-swales etc. they are all variations on the same basic principal - use landscaping and soil to manage and treat stormwater. Raingardens are very effective at reducing peak runoff rates, increasing groundwater recharge and improving water quality. They can also reduce potable water use for irrigation and provide for wildlife habitat. Landscaped areas are often lost opportunities for raingardens because they are raised planting beds. By depressing those planting beds the aesthetic appeal of the the landscape can be maintained and they can serve the additional purpose of stormwater management.

2. 透水路面

   透水路面can come in the form of asphalt, concrete, pavers or plastic grids to protect the soil. Pervious paving systems reduce peak runoff rates, increase groundwater recharge, improve stormwater quality and reduce the heat island effect. These systems are versatile and cost competitive, especially in areas where land is expensive or difficult to come by.

3. Wetlands

   Wetlands are nature's way of managing stormwater quantity, quality and flow rate and they are very effective in doing so. Existing, improved, constructed and modular wetland systems can be used to manage stormwater quantity, rate and quality in addition to providing wildlife habitat. It makes perfect sense to look to the natural world for design cues and wetlands are a good fit for projects that have the space and the right environmental (soil, water source, etc) conditions.

4. Green-roofs

   Green roofs有各种形状和大小,密集和extensive, modular and built up, sloped and flat, but they all have the same basic benefits. From a stormwater perspective, green roofs reduce peak and total runoff, improve water quality and provide for evapotranspiration. Other benefits include extended roof life, reduced cooling and heating loads, a reduction in the urban heat island effect, wildlife habitat and aesthetic appeal.

5. Rainwater capture

   水的大量落在我们的结构，这通常会导致径流增加的屋顶。通过捕获降雨和重用它的建筑，你可以省钱，水和能源，增加地下水补给，改善水质内园林灌溉和/或灰水。

The above methods are just a few of the many best management practices that can be used to manage stormwater rather than detention/retention ponds. Used alone or in any combination they can provide better stormwater quality, reduced runoff, increased groundwater recharge, peak rate reductions, less potable water use and a host of other benefits. Another great thing about these best management practices is that they can often save the owner money both in first cost and long term operations and maintenance costs. I don't know about you, but to me it sounds like a "no-brainer".

As with many green methods and technologies the biggest deterrent is often lack of knowledge. Lack of knowledge by the design engineer, the contractor, the owner and stormwater regulators. The best way to overcome that lack of knowledge is to educate yourself and others and give these best management practices a try. The best way to learn about them is to design and use them. The city of Portland and Seattle Washington have very good, readily available resources as well as Prince Georgia's County Maryland and countless other programs that have begun implementing these systems around the country.